講演抄録/キーワード |
講演名 |
2014-12-19 11:30
マイクロストリップ線路によるSパラメータ法用ジグの検討(その4) ~ 基板端コネクタによる測定値への影響 ~ ○笹森崇行・遠藤和麻・戸花照雄・礒田陽次(秋田県立大) |
抄録 |
(和) |
ダイポールアンテナやループアンテナといった平衡給電を行うアンテナの入力インピーダンスを測定するためにSパラメータ法と呼ばれる測定法が提案されている.これは平衡給電アンテナのSパラメータをベクトルネットワークアナライザで測定し,計算によって入力インピーダンスの値を導出する方法である.この測定法では,測定周波数が高くなるにつれて測定用ジグの影響が無視できなくなることにより,測定精度が悪くなることが知られている.本報告ではSパラメータ法の測定精度を向上させることを目的として,測定用ジグに使用する基板端コネクタの影響を実験的に調べる.2種類のコネクタを用いてジグを製作し,ダイポールアンテナの入力インピーダンスを測定する.これらの測定値をKingにより求められた値,及び,2種類の解析モデルを用いたFDTD法の計算値と比較した.その結果,基板端に固定するための4本の支えがあるコネクタは,6~7GHz以上の周波数において測定値に誤差が現れることを示した. |
(英) |
Recently, the S-parameter method using a vector network analyzer and a measurement jig instead of a balun has been pro-posed whereby the differential input impedance of a balanced fed antenna can be found. Because the balun is not used, it is possible to measure impedance over a wide bandwidth. However, when measured frequency rises, it is known that measure-ment accuracy decreases because the influence of the jig cannot be disregarded for the measurement. In this report, to im-prove the measurement accuracy of S-parameter method, the influence of the substrate edge connector installed on the jig for the measurement is experimentally examined. The jig is fabricated by two kinds of edge connectors, and the input impedance of a dipole antenna is measured by the S-parameter method. The measured values are compared with the available theories by King and the calculated values that used two kinds of FDTD models. As a result, the jig using the edge connector with four support to fix to the substrate edge showed that the measured error is observed above the frequency from 6 to 7 GHz. |
キーワード |
(和) |
Sパラメータ法 / 平衡給電アンテナ / 入力インピーダンス / 改良型開放端補正 / 基板端コネクタ / / / |
(英) |
S-parameter method / balanced fed antenna / input impedance / modified open correction / edge connector / / / |
文献情報 |
信学技報 |
資料番号 |
|
発行日 |
|
ISSN |
|
PDFダウンロード |
|