講演抄録/キーワード |
講演名 |
2007-04-27 16:45
コモンモードアンテナモデルによるコネクタ接続されたプリント回路基板からの放射電磁波予測 ○貞利章文・酒井陽平(岡山大)・渡辺哲史(岡山県工技センター)・豊田啓孝・五百旗頭健吾・古賀隆治(岡山大)・和田修己(京大) EMCJ2007-9 |
抄録 |
(和) |
マザーボードとドーターボードがコネクタを介して接続されている場合,コネクタ部のグラウンドピン数を変えたときにプリント回路基板
(Printed Circuit Board: PCB)のコモンモード放射量が変化することが報告されている.この放射量の変化について,
これまでに我々のグループでPCBからの放射予測を高速に行うために提案してきたコモンモードアンテナモデルを用いることで
説明できるのかどうかを実際にコネクタ接続基板を作製し,その遠方電界放射の測定と比較することで検証した.
コモンモードアンテナモデル構築の際,コモンモード電位変換係数よりプリント回路基板上のコモンモード電位分布を求め,その電位差をコモンモード励振源とする.
これを基板上に配置しアンテナ解析することで遠方電界放射を求めた.
実測と計算を比較する際,コネクタ接続基板ではグラウンドピン数によってコネクタ部の特性インピーダンスが変化することも考慮した.
ボード部とコネクタ部の平衡度を調べ,その差が少なくなるようなコネクタを設計することでコモンモード放射を低減することができることが分かった. |
(英) |
The amount of radiated emission from the connector between the motherboard and the daughterboard depends on the number of ground pins.
This paper discusses the prediction of the amount of radiated emission from printed circuit boards with a connector using the common-mode antenna model proposed by the authors.
the effect of reflection of an unmatched interface such as the connector-board was taken into account by using the measurement result of normal mode voltage in simulation.
Common-mode emission is reduced by decreasing imbalance between the connector and the board. |
キーワード |
(和) |
コネクタ / グラウンドピン / コモンモード電位変換係数 / コモンモードアンテナモデル / / / / |
(英) |
connector / groundpins / common-mode potential coversion factor / common-mode antenna model / / / / |
文献情報 |
信学技報, vol. 107, no. 25, EMCJ2007-9, pp. 49-54, 2007年4月. |
資料番号 |
EMCJ2007-9 |
発行日 |
2007-04-20 (EMCJ) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMCJ2007-9 |