講演抄録/キーワード |
講演名 |
2007-10-25 10:55
異なる方向へ向けた線状導体を接続したプリント基板からの電磁波放射 ○高嶋将大・戸花照雄・笹森崇行・阿部紘士(秋田県立大) EMCJ2007-56 MW2007-103 エレソ技報アーカイブへのリンク:MW2007-103 |
抄録 |
(和) |
有限な大きさのプリント回路基板からの放射電磁波は,基板上を流れるコモンモード電流が発生することにより深刻になる.これらのコモンモード電流は,基板の線路構造の不連続や外部からの導線の接続部分において発生すると考えられている.本報告では,プリント基板の端部に線状導体を接続した場合の電磁波放射について検討している.線状導体の長さと接続する方向を変化させたときの放射電磁波をFDTD法を用いて解析した.また,基板の寸法を変化したときの解析を行った.その結果,線状導体を基板に垂直に接続した場合,放射電力が大きくなることがわかった.また,基板の幅が小さくなるにつれて放射電力は,大きくなることがわかった.また,放射電力の測定結果を解析結果と比較することにより,解析結果の妥当性を示した. |
(英) |
Emission from a printed circuit board (PCB) with finite size becomes serious when common mode currents are excited on it. Such a common mode current may be occurred at discontinuity of a line or a ground on the PCB, or at a connection of conducting wire. In order to clarify the relation between a attached conducting wires and emission, the authors analyzed emission from PCB attached a conducting wire to any direction at a edge of the ground plane using finite difference time domain method. In this report, emission from a printed circuit board attached a linear conducting wire was examined. When a conducting wire with various lengths and various directions attached radiation was calculated by the FDTD method. And also, the emission was calculated when the dimension of the PCB was changed. The results showed that the radiation power increased, when the linear conducting wire was perpendicularly connected with the PCB and when the width of the PCB decreased. The validity of the analysis was shown by comparing measurement results with the numerical results. |
キーワード |
(和) |
PCB / FDTD法 / 線状導体 / / / / / |
(英) |
PCB / FDTD / conducting wire / / / / / |
文献情報 |
信学技報, vol. 107, no. 278, EMCJ2007-56, pp. 19-24, 2007年10月. |
資料番号 |
EMCJ2007-56 |
発行日 |
2007-10-18 (EMCJ, MW) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMCJ2007-56 MW2007-103 エレソ技報アーカイブへのリンク:MW2007-103 |