講演抄録/キーワード |
講演名 |
2010-12-17 13:25
銅箔の直接電磁圧接(第2報) ○相沢友勝・松澤和夫・岡川啓悟(都立産技高専) EMD2010-130 エレソ技報アーカイブへのリンク:EMD2010-130 |
抄録 |
(和) |
部分的に重ねた銅箔2枚の外側を絶縁し,電流集中部分の幅が1,3または5mmの平板状ワンターンコイルの上面に固定する.コンデンサ電源からコイルに放電大電流を流す.銅箔には,高密度の磁束が交差し,渦電流が流れ,電磁力が働く.この渦電流加熱と電磁力により,重ねた銅箔は圧接され得る.コンデンサ電源の容量を12μF,充電エネルギーを2kJ以下に選び,厚さ50μmの銅箔を長さ25mmにわたり溶融させずに直接圧接できた.この電磁圧接法の原理,方法および実験結果について報告する. |
(英) |
This paper describes a copper foil welding technique by using magnetic pulse welding method without drivers and its experimental results. When an impulse current from a capacitor bank passes through a flat one-turn coil, a magnetic flux is suddenly generated around the narrow part (1 or 3 or 5mm in width) of the coil. Eddy currents are induced in two pieces of foil (50μm in thickness) which are overlapped on the narrow part. The pieces of foil can be welded without fusion both by the Joule heat generated in them and by the magnetic pressure applied to them. The bank energy required for seam welding of 25mm in length is less than 2kJ. |
キーワード |
(和) |
銅箔 / 電磁圧接 / 電磁力 / 渦電流 / 平板状ワンターンコイル / / / |
(英) |
Copper foil / Magnetic pulse welding / Magnetic pressure / Eddy current / Flat one-turn coil / / / |
文献情報 |
信学技報, vol. 110, no. 350, EMD2010-130, pp. 5-10, 2010年12月. |
資料番号 |
EMD2010-130 |
発行日 |
2010-12-10 (EMD) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
EMD2010-130 エレソ技報アーカイブへのリンク:EMD2010-130 |