| 講演抄録/キーワード |
| 講演名 |
2011-06-24 11:15
インピーダンス変成器を設けたブリッジ形高周波整流回路の基本検討 ○佐圓恒啓・伊東健治・別段信一・牧野 滋・廣田哲夫・野口啓介(金沢工大)・下沢充弘(三菱電機) MW2011-39 |
| 抄録 |
(和) |
本報告では,ブリッジ形高周波整流回路の基本検討結果を示す.
このブリッジ形高周波整流回路は,付加回路なく全波整流動作が可能であり,小型化,集積化に適する利点がある.
ここではブリッジダイオードの入力側にインピーダンス変成器を設け,高効率化を図る構成とする.
本構成の整流効率の解析式を示し,高整流効率条件でのインピーダンス変成器の設計条件が,負荷抵抗を含めたインピーダンス整合条件であることを示す.
さらにダイオードのブレークダウン電圧と最大入力電力により決まる整流効率の限界値を明らかにする.
このインピーダンス変成器を設けたブリッジ形高周波整流回路の試作を行い,整流効率の式の妥当性や平滑用キャパシタによる整流効率の改善を確認する. |
| (英) |
In this report, fundamentals of the bridge RF rectifier with an impedance transformer is described.
Radio wave can be full-wave-rectified by the bridge RF rectifier without a harmonic termination circuit.
Thus the bridge RF rectifier can be implemented in the miniaturized size.
Furthermore an impedance transformer is added between the input port and the bridge diode to improve rectification efficiency.
Based on the above configuration, formulas of the rectification efficiency are derived.
The formulas clarify the design condition of the impedance transformer, and this condition is the same as the impedance matching one.
In addition to above, fundamental limitation of the rectification efficiency restricted by the break-down voltage and the maximum input power can be clarified.
Finally experimental investigations are demonstrated. Derived formulas can be confirmed.
Also improvement of rectification efficiency can be realized by the additional capacitors for the short-circuit. |
| キーワード |
(和) |
高周波整流回路 / ブリッジ形整流回路 / / / / / / |
| (英) |
RF Rectifier / Bridge Rectifier / / / / / / |
| 文献情報 |
信学技報, vol. 111, no. 95, MW2011-39, pp. 41-46, 2011年6月. |
| 資料番号 |
MW2011-39 |
| 発行日 |
2011-06-16 (MW) |
| ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
| PDFダウンロード |
MW2011-39 |