講演抄録/キーワード |
講演名 |
2017-05-18 14:25
センダスト粒子を樹脂に分散させた二層型複合電磁波吸収体の作製と評価に関する研究 ○梅本成貴・森河直樹・久保田 匠・吉田隆彦・佐藤祐喜・吉門進三(同志社大) MW2017-9 エレソ技報アーカイブへのリンク:MW2017-9 |
抄録 |
(和) |
軟磁性材料あるセンダスト(Fe:85%-Si:10%-Al:5%)をポリチレン樹脂に分散させた複合体を用いて作製された単層型複合電磁波吸収体は平均粒径3.5 μm,体積混合率20.0 vol%付近の場合,吸収中心周波数8 GHz付近で規格化‒20 dB 吸収帯域幅は約29 %となり,一般的な吸収体の約 10 %と比較して極めて広帯域なものであった。しかし,複合電磁波吸収体を実用化するためには吸収周波数のさらなる広帯域化および斜入射特性の改善が必要である。本研究では吸収特性の向上を目指して複合体の複素比透磁率と複素比誘電率の値より二層型電磁波吸収体の最適設計を行い,実際に試料を作製し吸収特性を評価した。その結果計算上では約32%の‒20 dB 吸収帯域幅が得られた。また実測値は計算値とほぼ一致し,作製された吸収体は単層型と比較して広帯域化が実現された。 |
(英) |
It has been reported that the metal-backed single layer electromagnetic absorbers fabricated using the composite made of spherical shaped sendust (Fe-Si-Al) particles dispersed in polystyrene resin showed the broad band absorbing characteristics in the frequency range above sever-al GHz. The maximum normalized −20 dB absorption bandwidth was ≈29 % for the average particle size of 3.5 μm and the volume ratio of sendust of 20 % at ≈ 8 GHz. This value was broader that those for commercially available absorbers (≈ 10 %). However, in order to use com-posite electromagnetic wave absorbers in practical use, the absorbing characteristic needs the larger −20dB absorption bandwidth and the better oblique incident characteristics. In order to improve the absorption characteristics, the optimal design of a two-layer type electromagnetic wave absorber with the two layered structure was performed using the values of both the complex permeability and the complex permittivity and the samples were actually fabricated. As a result on calculation, the larger −20dB absorption bandwidth of ≈ 32 % was obtained. Moreover, the actual measurement of the absorbing characteristics was performed. Measured values agreed with the calculated values and the broadband ab-sorbing characteristic was realized as compared with the single layer type. |
キーワード |
(和) |
二層型電磁波吸収体 / 広帯域吸収 / センダスト粒子 / ポリスチレン樹脂 / リターンロス / / / |
(英) |
Double Layered Electromagnetic Wave Absorbers / Wide band Absorption / Sendust Particles / polystyrene resin / Return Loss / / / |
文献情報 |
信学技報, vol. 117, no. 34, MW2017-9, pp. 7-12, 2017年5月. |
資料番号 |
MW2017-9 |
発行日 |
2017-05-11 (MW) |
ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
PDFダウンロード |
MW2017-9 エレソ技報アーカイブへのリンク:MW2017-9 |