| 講演抄録/キーワード |
| 講演名 |
2020-07-10 11:10
フィードフォワード制御のみを用いたディジタル制御降圧形コンバータにおける過渡特性の改善について ○住田令央・佐藤輝被(大分大) EE2020-10 |
| 抄録 |
(和) |
著者らはこれまでに,降圧形コンバータにおいて負荷電流及び入力電圧を検出し,時比率の操作量を決定するフィードフォワード制御のみを用いた制御手法を提案した.フィードフォワード制御のみを用いるため閉ループが存在せず,発振の恐れが無いことや容量性および誘導性負荷に接続した際の位相余裕やゲイン余裕の変化による安定性劣化が生じないという利点がある.降圧形コンバータにおいて,回路定数のインダクタンスとキャパシタンスの遮断周波数が高いとき,PID制御と同等以上の過渡特性が得られた.しかし,その他のパラメータにおいてはPID制御に劣る結果であった.そこで本論文では,フィードフォワード制御の操作量に周波数特性を持たせることで,過渡特性の改善を試みた.その結果,過渡特性の改善が確認できた. |
| (英) |
We have proposed a control method of a switching power supply using only feed-forward control, which is reflected in the duty ratio, by calculating the influence of these disturbances on the output voltage by detecting the load current and input voltage. Since only feed-forward control is used, there is no closed loop and there is no possibility of oscillation, and there is no degradation of stability due to changes in phase margin and gain margin when connected to capacitive and inductive loads. In buck converter, when the inductance of the circuit constant and the cutoff frequency of the capacitance is high, the transient characteristics equivalent to or better than those of the PID control is obtained, but other parameters were inferior to the PID control. Therefore, in this paper, we attempt to improve the transient characteristics by considering the AC component in the correction calculation of the influence amount. |
| キーワード |
(和) |
ディジタル制御 / フィードフォワード制御 / 降圧形コンバータ / / / / / |
| (英) |
Digital control / Feedforward control / Buck converter / / / / / |
| 文献情報 |
信学技報, vol. 120, no. 92, EE2020-10, pp. 31-36, 2020年7月. |
| 資料番号 |
EE2020-10 |
| 発行日 |
2020-07-02 (EE) |
| ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
| PDFダウンロード |
EE2020-10 |