| 講演抄録/キーワード |
| 講演名 |
2020-12-03 15:35
マイクロ波アシスト磁気記録媒体の設計 ○サイモン グリーブス(東北大)・金井 靖・板垣 諒(新潟工科大) MRIS2020-9 |
| 抄録 |
(和) |
3 種の磁気スペーシング(ヘッド媒体摺動面から媒体表層の距離)に対して、書き込みヘッドとスピントルク発振器(STO)によるマイクロアシスト磁気記録の記録シミュレーションを行った。それぞれの磁気スペーシングに対して単層およびECC 媒体の異方性エネルギー(Ku)を最適化した結果、ECC 媒体に書き込まれたビットは、単層媒体に書き込まれたビットよりも遷移領域が直線的で、記録ビット磁化の平均値が大きいことが分かった。また、磁気スペーシングが増加するにつれて、(ソフト層のKu)/(ハード層のKu)が小さいほどECC 媒体の記録特性が向上した。なお、磁気スペーシングが14.5nm のときはSTO が記録媒体に明瞭なビットを書き込むことは困難であった。 |
| (英) |
Microwave-assisted magnetic recording is simulated using write heads and spin torque oscillators (STO) with three different magnetic spacings. Single phase and ECC media were optimised for use with each magnetic spacing. Bits written on ECC media had straighter transitions and higher average bit magnetisation than bits written on single phase media. As the magnetic spacing increased the recording performance of ECC media optimised at a lower soft layer Ku to hard layer Ku ratio. When the magnetic spacing was 14.5 nm it was difficult for the STO to write clear bits on the media. |
| キーワード |
(和) |
マイクロ波 / アシスト / 磁気記録 / シミュレーション / 媒体 / スピントルク発振器 / / |
| (英) |
microwave / assisted / magnetic / recording / simulation / spin torque oscillator / / |
| 文献情報 |
信学技報, vol. 120, no. 274, MRIS2020-9, pp. 20-25, 2020年12月. |
| 資料番号 |
MRIS2020-9 |
| 発行日 |
2020-11-26 (MRIS) |
| ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
| PDFダウンロード |
MRIS2020-9 |