| 講演抄録/キーワード |
| 講演名 |
2008-06-27 13:20
正弦波発振回路の性能を最大化するための準線形回路理論 ○ウリン トヤ・大平 孝(豊橋技科大) MW2008-40 |
| 抄録 |
(和) |
本文では正弦波発振回路の性能を最大化するための準線形回路理論として、回路トポロジや回路素子を最適化するための便利で有効な手法を提案する。この理論では、回路を構成する任意の枝の一端を切断し、その切断点から回路を見た能動インピーダンスを観測する。観測されるインピーダンスは周波数ならびにFETの伝達コンダクタンスgmの関数である。ここでの要点は、gmの非線形性が、負のAM/AM係数を持っていることである。gmが唯一の最大非線形要素であると仮定し、その他は比較的小さいとし無視する。これで、本手法が非線形シミュレータに頼らずに、発振回路の基本性能である発振振幅、搬送波側波帯雑音比を所要の周波数において、最大化する手順を大幅に簡易化する。構成が簡単である回路の場合は最適解を解析的に求めることができる。回路構成が複雑である場合であっても本手法により線形小信号回路解析シミュレータで数値的に求めることができる。 |
| (英) |
This paper proposes an effective measure as objective function for quick optimization of the circuit topology and parameters in sinusoidal oscillators. The theory begins with paying attention to the impedance of the circuit virtually cut at a branch. This is called active impedance as a function of not only frequency but also device gain. The key point is that the device gain, such as gm of FET, exhibits nonlinearity with inherently a negative AM/AM conversion coefficient. We assume it to be the only major nonlinear factor and neglect others as minorities. This enables the measure to work without resorting to nonlinear circuit simulator, and drastically simplify the maximization process of primarily concerned terms of oscillator performance, i.e., oscillation amplitude and carrier-to-sideband-noise ratio at the specified frequency. The measure can derive optimum solution by analytical formulation for oscillators in basic topology. For ones in too complicated topology to be analyzed by hand-writing formulation, the measure can even carry out numerical optimization with an aid of only a linear circuit simulator. |
| キーワード |
(和) |
発振回路 / 最適化 / 回路トポロジ / 回路素子 / Qファクタ / / / |
| (英) |
Oscillator / Optimization / Circuit topology / Circuit parameter / Q factor / / / |
| 文献情報 |
信学技報, vol. 108, no. 118, MW2008-40, pp. 47-52, 2008年6月. |
| 資料番号 |
MW2008-40 |
| 発行日 |
2008-06-20 (MW) |
| ISSN |
Print edition: ISSN 0913-5685 Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
| PDFダウンロード |
MW2008-40 |