| 講演抄録/キーワード |
| 講演名 |
2024-06-25 15:45
[ポスター講演]塗布形成CNT膜をPDMSに埋め込んだ抵抗式伸縮センサの作製 ○工藤晴世・伊東栄次(信州大) OME2024-12 |
| 抄録 |
(和) |
伸縮性ゴムの柔らかさとCNTの特性を利用した伸縮センサの開発が国内外で進められている. 本研究はPDMS伸縮性ゴムの表面に往復メニスカス法により膜厚制御したCNT膜を埋め込んだ抵抗式伸縮センサの作製を試みた. 作製したセンサを0~100 %及び 1 %前後の範囲で伸縮した際の抵抗の変化を伸縮性が高いPDMSを用いて比較した. また, 単層CNTと多層CNTを埋め込んだ場合の違いやポリイミドをレーザで焼いて得られたグラフェン(LIG)をPDMSに埋め込んだ場合なども比較した. |
| (英) |
In this study, we investigate a simple and low-cost fabrication technique for highly stretchable and/or soft strain sensors by combining the meniscus coating and transfer-printing of carbon nanotubes and PDMS elastomer films. The thickness of single or multi-walled carbon nanotubes films were controlled by changing the number of sweeping times of glass rods and sweep speeds, and the CNT films were embedded in PDMS elastomer surface. We investigated the relationships between the strain (%) and the relative resistance change ΔR/R0 up to 100 % strain, and small strain range (~1 %) for SWCNT films. We also embedded MWCNT films and laser-induced-graphene (LIG) obtained from polyimide sheet in PDMS for comparison. |
| キーワード |
(和) |
伸縮センサ / カーボンナノチューブ / PDMS / / / / / |
| (英) |
Stretchable sensor / Carbon nanotube / PDMS / / / / / |
| 文献情報 |
信学技報, vol. 124, no. 89, OME2024-12, pp. 17-20, 2024年6月. |
| 資料番号 |
OME2024-12 |
| 発行日 |
2024-06-18 (OME) |
| ISSN |
Online edition: ISSN 2432-6380 |
著作権に ついて |
技術研究報告に掲載された論文の著作権は電子情報通信学会に帰属します.(許諾番号:10GA0019/12GB0052/13GB0056/17GB0034/18GB0034) |
| PDFダウンロード |
OME2024-12 |